Although you can cut the wet lawn, we do not recommend it, since cutting the grass when it is wet increases safety risks and is not good for the health of your grass.
But if he lives in a wet area of the country where he rains without stopping for prolonged periods, he finally cut a humid grass becomes inevitable. Corting slowly at a higher height, keeping the blades of the cutcase and the use of a silicone spray are just some of the ways to cut the wet grass without causing damage to its grass or the cutting equipment.
Overcome water on the grass with garden hose
When cutting the humid grass is inevitable, here there are two ways in which you can wear a garden hose to reduce the amount of humidity on your grass.
Squeregee Method: With a hose, you can reduce the amount of humidity sitting in your herb. This helps your grass dry faster. To eliminate the dew of the morning or the excess moisture of the rain, drag a hose through its grass to hit the drops of water and let the soil absorb excess water.
Siphon method: For the puddles in your patio, divert the water away from your grass to help your grass dry.
- Fill your garden hose with water. Turn off the nozzle.
- Place the tight hose in a puddle. It must be completely submerged.
- Place the hose nozzle end near a drainage where you can deposit water. It must be lower than the water source so that the liquid can flow down. Then disconnect the nozzle.
- The hose will automatically shake water from your patio. Let it run until you can no longer divert water.
https://www.youtube.com/watch?v=vqiiie7-lu8
If your patio is so soaked in the recent rains that you are considering diverting the excess, consider letting the sun rise before cutting.
Although the siphon can help, “cut [a wet lawn]—Put with heavy equipment, it can result in depressions that alter (unfavorably) the surface uniformity. In these circumstances, the cut must be delayed until the grass dries and the surface becomes firm, ”says Alfred Turgeon, former lawn management professor at the College of Agricultural Sciences of Penn State.
| If you do not want to deal with cutting a wet lawn yourself, hire a process to cut your patio for you. Our clients pay an average of $ 48 for cutting service. |
Keep the blades of the sharpened host
Opaque blades shatter the grass instead of cutting it, and it is difficult for opaque blades to cut the damp grass. To minimize the quantity of tension in your grass cutter, it affirms your corteped blades before cutting.
See related: How often should you sharpen the corteped blades?
Raise the height of the cortesped
You are more likely to get a uniform cut if you place your cutter a few notches above the normal cutting. This generally means establishing the cutting height at 4 inches more or less.
When established in a higher environment, the cutter does not have to work so hard. Since there is less grass to trim, it also reduces the probability of a clogged cortempted.
Apply cover spray
A silicone lubricant spray is a non -stick spray that prevents dirt and grass cuts from adhere to the bottom of their corteped.
To reduce the possibilities of an obstruction, apply the nonstick spray to the cutting cover and the discharge channel before cutting. To properly apply a cover spray:
- Disable the power supply (cable, spark plug, drums)
- Clean the cutting cover and blades before applying the aerosol.
- Let the spray dry before use.
Don’t be cuts
When the grass is wet, grass cuts in bags increase the risk of a host -hi -grass obstruction caused by wet grass. To facilitate the cut of wet grass, open the side discharge channel instead of pocketing.
This is what happens when it does not pocket grass cuts on a humid grass:
- Reduces tension in your corteped.
- It helps prevent clogs on your cutter of the corteped.
- It reduces the weight of heavy grass on its corteped, which makes its corteped lighter and easier to push.
- Grass cuts can become fertilizers that provide nutrients to their grass.
If you must pocket the grass cuts, empty the bag frequently to reduce the tension in you and your corteped.
See related: What is Grasscycling?
Cut slowly
Your patio is not a racing track. A hurried -cut work creates an irregular, unequal cut, even on a dry day. But wet grass is thick and requires more effort so that the chills of the cutter are cut evenly. To end with a uniform adjustment, Wet grass fire at a stable pace (approximately half of its usual cutting speed).
Overlapping passes in 50%
Overpiever passes by 50%. That means that half of each row should be cut with grass and the other half must be without cutting. This allows its cutting to cut the wet lawn effectively, reducing the amount of tension in the corteped. Ultimately, when the work is done, you will have cut each area of your grass twice.
Cut in half of the passes also breaks groups of grass cuts and extends them to form a uniform layer on their patio.
Change direction
When cutting the wet lawn, change the cutting address every time it cuts. For a week, cut the vertical ranks. Then, the following week, go down in horizontal rows. This retains the aesthetic attractiveness of your lawn by preventing the cutting grass unevenly.
Apply the rule of a third
The rule of one third for the cut dictates that it should never eliminate more than a third of its grass blades during a single cutting session. It is difficult for a grass cutter gently cut the wet lawn, so it does not strain its cutting cutting more grass than it needs.
Thorough clean woman
After finishing cutting, clean the cutting cut and the chores of the corteped. Verify that there are no wet grass cuts stuck on the cutting deck or obstruct the filter.
Make it a habit to clean your corteped (especially the cutting cover) after each blinding, even after cutting the dry grass.
My advice: I keep a hand broom to clean my grass cutter stored in my shed next to my other cutting equipment. After each cut, immediately brush the dust and dead grass of my corteped and Clean the filter Before saving the corteped.
Dry equipment
The cutting equipment must be dry when it begins and ends, so it dries its cortempted well after cleaning it to avoid oxide and corrosion. Let the blades work (if you use the port of the port cover), use a cloth or hit with a leaf blower to disperse the remaining water drops. Once it is dry, this is a good time to apply a deck spray (see advice above) to provide more protection.
Frequent questions about cutting wet grass
Cutting the humid grass can be dangerous, so here there are some security precautions to take:
• Do not cut while it rains. Cut in the rain can permanently damage a corteped engine.
• Do not use grass cutters with electric motor. Protect it of electrocution not using electric cutters on a humid grass.
• Use resistant footwear. Use shoes with good traction and strong support to reduce the possibilities of sliding over moist grass.
• Avoid cutting hills. Wet grass is slippery and facilitates falling on a hill or inclination when the grass is wet. For a grass that grows on a slope, wait until it dries to cut.
To avoid cutting the cut, consider some alternative methods to cut grass:
• PARTIAL CAJE: Separate your patio into different areas and cut each area separately at a different time.
• Garrison: A string trim (also known as Weed Wacker) is an alternative to the traditional cut, especially for small yards.
• HAND CORDILLETE: “Another alternative is the hand, a laborious method that requires some ability to achieve a uniform cut,” says Turgeon.
• Sheep: Turgeon also suggests using sheep to maintain the height of the low grass. “This was the dominant method before the invention of the grass cutter in 1830,” he says.
Light grass cutters with gas with a side discharge are the best type of corteped to cut the humid grass. Avoid using padded grass cutters.
Security Council: Never Use an electric grass cutter on wet grass. They are a danger of security in wet areas, since the mixture of electricity and water increases the risk of electrocution.
Hire a professional to cut your lawn
When it is impossible to wait for your grass to dry, you can reduce the tension in your corteped following the cutting rule of a third, raising the height of your host and not embolizing. Cut slowly and overlapping passes in 50% also helps relieve the task of cutting the humid grass.
If your area has been experiencing a long rain season with few breaks and does not have time to cut it yourself, look for a professional lawn care in your area today.
Read more:
Main image credit: Triceano / Adobe stock
Danielle Gorski
Danielle Gorski combines his love for plants with his love for writing to create informative articles about the care of the grass. His favorite part of his patio is to decorate it for the holiday season.
